It is a titanium based insert which is very light.
Ceramic vs carbide inserts.
Ceramic inserts are 2 3 times more expensive compared to carbide.
Sic has been advertised to even be able to handle light wire line.
Whisker ceramic inserts are for moderate hardness machining at high surface speeds.
Sic can withstand any braided or super line without grooving.
It is commonly used on non ferrous materials including aluminum and magnesium alloys.
However due to metal removal rates achieved the cost per edge is less than carbide.
For ceramic tools cvd coatings are the most common coatings starting from a dual layer system and going up to a multilayer system.
Do you need a high power or high speed machine tool.
The definitions of ceramics have changed greatly since early days.
Because ceramics do not bond as easily as other materials much higher temperatures must be used during sintering.
Ceramic inserts are created in a process very similar to that used for cemented carbide.
Silicon carbide sic one of fuji s hardest and most popular insert materials.
Made of ceramic particles bonded together with a nickel binder these tools are capable of running at higher speed than carbide tools and are much more wear resistant.
You are probably on the low end of speeds for a ceramic insert at 600 sfm.
The surface of these inserts is very smooth allowing the chip to flow easily and prevent built up edges.
Smith ceramic inserts show flaking along the cutting edge.
Inserts used a ceramic.
Here is a breakdown of some of the most popular ceramic inserts.
Properties of tungsten carbide and ceramic tools properties tungsten carbide ceramic hardness ra 90 95 91 95 compressive strength mpa 4100 5850 2750 4500 transverse rupture strength mpa 1050 2600 345 950 impact strength j 0 34 1 35 0 1.
Tic tin or al 2 o 3 layers are the most common ntk cutting tools howard concurred that ceramic inserts are primarily cvd coated but the coatings themselves have a limited effect on overall performance.
High pressures are also used.
There are grades of carbide that will do 600 sfm and you re going to negatively affect the life of the insert by machining too slowly.
B carbide table 2.
Carbides such as tungsten carbides are made with tungsten carbide particles glued together with cobalt depending on type they vary with percentage of cobalt and size of carbides.
Titanium diboride tib2 is a corrosion resistant ceramic compound made of titanium and boron.
Ceramics are sometimes sintered heated to bond the particles without a secondary glue.
Normal wear patterns for reinforced ceramic inserts are unlike wear patterns seen on carbide inserts.